CSA - CSA Group: Recent submissions
Now showing items 841-860 of 5597
-
CSA CAN/CSA-C22.2 NO. 227.1-06
Abstract: This Standard applies to corrugated electrical nonmetallic tubing (ENT) and mechanically-attached fittings, for use in accordance with C22.1, Canadian Electrical Code, Part I (CEC), and NFPA 70, National Electrical Code ... -
CSA CAN/CSA-IEC 61400-24:12
Abstract: This International Standard applies to lightning protection of wind turbine generators and wind power systems.
Normative references are made to generic standards for lightning protection, low-voltage systems and ... -
CSA CAN/CSA-E60335-2-52-01
Abstract: This clause of part 1 is replaced by:
This standard deals with the safety of electric oral hygiene appliances for household and similar purposes, their rated voltage being not more than 250 V.
NOTE 1 - Examples of ... -
CSA C22.2 NO. 131-07
Abstract: This Standard applies to single- and multi-conductor Type TECK 90 armoured cable intended for installation in accordance with the Rules of the Canadian Electrical Code, Part I, on systems having nominal voltages of 5000 V ... -
CSA CAN/CSA-E61347-2-3:03
Abstract: This part of IEC 61347 specifies particular safety requirements for electronic ballasts for use on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz with operating frequencies deviating from the supply frequency, associated ... -
CSA CAN/CSA-ISO/IEC 14496-4:06
Abstract: This part of ISO/IEC 14496 specifies how tests can be designed to verify whether bitstreams and decoders meet requirements specified in parts 1, 2 and 3 of ISO/IEC IEC 14496 and for part 6 of ISO/IEC 14496 it specifies how ... -
CSA CAN/CSA-ISO/IEC-7776-96
Abstract: This International Standard defines an application of the following HDLC standards: ISO/IEC 3309, ISO/IEC 4335, IS0 7478. and ISOiIEC 7809. When there is difficulty in the interpretation of a reworded requirement from one ... -
CSA CAN/CSA-ISO/IEC 15026-3:13
Abstract: This part of ISO/IEC 15026 specifies the concept of integrity levels with corresponding integrity level requirements that are required to be met in order to show the achievement of the integrity level. It places requirements ... -
CSA C22.2 NO. 210-11
Abstract: This Standard applies to single- or multiple-conductor, round, flat, or coiled appliance wiring material products classified as follows:
(a) Class I — internal wiring of equipment (single- or multiple-conductor ... -
CSA CAN/CSA-ISO 4903-95
Abstract: This International Standard specifies the 15-pole connector and the assignment of contact numbers at the interface between data terminal equipment (DTE) and data circuit-terminating equipment (DCE) where CClTT 1) ... -
CSA S347-14
Abstract: This Standard provides basic procedures based on joint ultimate load or a limiting slip for the determination of the lateral strength resistance and lateral slip resistance of truss plate teeth embedded in sawn and structural ...

درباره ما