NATO - North Atlantic Treaty Organization: Recent submissions
Now showing items 721-740 of 1523
-
NATO AFLP-6
Abstract: INTRODUCTION
From the moment it leaves the refinery fractionation column, fuel is polluted by the surrounding air and run-off water during handling and storage.
Two types of micro-organisms may develop: ... -
NATO STANAG 3200
Abstract: AIM
The aim of this agreement is to establish minimal requirements for anti-G systems to ensure each nation provides comparable levels of acceleration protection. -
NATO STANAG 2221
Abstract: AIM
The aim of this agreement is to register national acceptance of AEODP-6(A) -
NATO STANAG 3666
Abstract: AIM
The aim of this agreement is to standardise the maximum sizes for maps, aeronautical charts and other geospatial products (excluding nautical charts) produced by NATO nations for their armed forces, such ... -
NATO STANAG 2577
Abstract: AIM
The aim of this NATO standardization agreement (STANAG) is to respond to the following interoperability requirements. -
NATO ATP-3.8.1 VOL 2
Abstract: ATP-3.8.1, Volume 2 provides NATO forces with the specialist NBC defence capabilities doctrine for the planning, execution and support of NATO joint operations where there is a risk of NBCattack or Release Other Than Attack ... -
NATO STANAG 3764
Abstract: AIM
The aim of this agreement is to establish the format and national points of contact for requesting imagery. -
NATO AEDP-11
Abstract: Aim
This Allied Engineering Document Publication (AEDP) provides the North Atlantic Treaty Organisation (NATO) Imagery Air Reconnaissance Tape Recorder community with technical guidance on ... -
NATO STANAG 2607
Abstract: AIM
The aim of this NATO standardization agreement (STANAG) is to respond to the following interoperability requirements. -
NATO AXP-6(C)
Abstract: Ten representative weapon yields and a wide range of targets have been included in this publication for use by personnel of land, air and naval forces in a wide variety of situations.
The data and procedures in this ... -
NATO AECTP 500
Abstract: Purpose
This document is intended to cover general and specific requirements relating to equipment and subsystems, guidance and requirements for development of a test program for all material characterised ... -
NATO STANAG 4432
Abstract: AIM
The aim of this agreement is to provide within NATO, mutually acceptable principles for safe design applicable to air-launched guided munitions and their support equipment. -
NATO STANAG 1458
Abstract: AIM
The aim of this agreement is to enhance the effectiveness of NATO forces when conducting joint diving operations, through the adoption of a uniform and safe level of gas quality for diving and marine life-support ... -
NATO STANAG 3208
Abstract: AIM
The aim of this agreement is to standardize air conditioning connections on aircraft for air conditioning on the ground of the aircraft and its installed equipment in order to facilitate cross-servicing to other ... -
NATO STANAG 3892
Abstract: AIM
The aim of this agreement is to establish parameters to govern the design and installation of apron floodlighting. -
NATO AJEPP-1
Abstract: The information contained in this AJEPP is meant to provide military commanders with guidelines in the application of environmental standards during the development of a NATO compound. These standards will be applied based ... -
NATO STANAG 1379
Abstract: AIM
The aim of this agreement is to define the requirement to mark areas where a hazard to personnel, munitions and ordnance and flammable materials exists due to the presence of radio-frequency radiation. -
NATO EXTAC 1003 REV A
Abstract: EXTAC 1003, Replenishment at Sea, is designed for use by NATO nations when conducting exercises or operations with non-NATO navies. Areas covered include planning and scheduling replenishment at sea, principles of ... -
NATO STANAG 4235
Abstract: AIM
The aim of this agreement is:
a. to define the electrostatic environment which may be experienced by all materiel utilized by the NATO Forces; and
b. to define the electrostatic levels to be used as ... -
NATO AMEDP-53
Abstract: AIM
The aim of this Allied Medical Publication (AMedP) is to facilitate cross-servicing of medical gas cylinders between NATO Forces.

درباره ما