درباره ما
TIA - Telecommunications Industry Association: Recent submissions
Now showing items 561-580 of 1186
-
TIA TIA-102.BACA-B
Abstract: This document provides a detailed specification of the messages and procedures required between RFSSs within a given LMR system, and across LMR systems, in order to provide mandatory voice services and SU mobility management. ... -
TIA TSB-88.1-D
Abstract: The TSB-88-C/D Series
The TSB-88.x-C & D series of bulletins gives guidance on the following areas:
• Establishment of standardized methodology for modeling and simulating narrowband/bandwidth ... -
TIA TIA-504-A
Abstract: This Standard defines magnetic field requirements for all handset telephones intended to couple magnetically with hearing aids.
This Standard also covers requirements for receive-amplified handset telephones intended ... -
TIA TIA-604-15
Abstract: FOCIS 15 presents the intermateability standard for connectors with the commercial designation of MF, and is used as an addendum to TIA/EIA-604, Fiber Optic Connector Intermateability Standards. The provisions of ... -
TIA TIA-455-133-A
Abstract: This part of IEC 60793 establishes uniform requirements for measuring the length and elongation of optical fibre (typically within cable).
The length of an optical fibre is one of the most fundamental values and shall ... -
TIA TIA-916-A
Abstract: This Specification details definitions, methods of measurement, and minimum performance characteristics for Position Location Capable Code Division Multiple Access (CDMA) mobile stations. This Specification shares the ... -
TIA TIA-136-610-B
Abstract: Introduction
R-DATA and SMDPP (Short Message Delivery – Point-to-Point) are the messages that are used for information transfer through the TIA/EIA-136 air interface and the TIA/EIA-41 network ... -
TIA TIA-612
Abstract: This Standard specifies the electrical characteristics of the balanced digital interface circuit, normally implemented integrated circuit technology, that may be employed when specified for the interchange of serial binary ... -
TIA TSB62-12
Abstract: This technical report is intended to characterize the microbend sensitivity of optical fibers, thereby guiding fiber and cable manufacturers regarding the design of various coatings and basic fibers as they apply to the ... -
TIA TIA/EIA-455-157
Abstract: This procedure can be applied to any single-mode passive component, including connectors, splices, couplers, attenuators, isolators and switches. It is used to measure the total range of insertion loss, a, due to changes ... -
TIA TIA-41.322-E
Abstract: INTRODUCTION
Unless otherwise noted, the scenarios in this Part depict features operating individually; i.e., feature interactions are not considered unless specifically noted.
The scenarios in ... -
TIA TIA-4940.020
Abstract: This document is a member of a multi-part standard that, when taken in total, defines the requirements for communications pertaining to the access agnostic (e.g. PHY and MAC agnostic) monitoring and bi-directional communication ... -
TIA TIA-455-198
Abstract: This procedure can be applied to any single-mode passive component, including connectors, splices, couplers, attenuators, isolators, switches, multiplexers and demultiplexers, optical amplifiers (non-operating), circulators ... -
TIA TSB10-F
Abstract: Introduction
This Bulletin provides methodology and criterifao r properly coordinating microwave radio systems in the merged (under FCC ET Docket 92-9) Domestic Public Fixed Radio Services and Private ... -
TIA TIA-733-A
Abstract: PREFACE
These technical requirements form a standard for Service Option 17, a variable rate, two-way speech service option. The maximum speech coding rate of the service option is 13.3 kbps.
This standard does not ... -
TIA TSB-87-1014
Abstract: Introduction
This Part is directed toward Cellular Digital Packet Data (CDPD) Service Providers and manufacturers intending to build equipment for use in the CDPD internal network. This part does not ... -
TIA TIA-2000.2-F
Abstract: General. This section defines the terms and numeric indications used in this document. This section also describes the time reference used in the CDMA system and the tolerances used throughout this Specification. -
TIA TIA-526-18
Abstract: Since random jitter and systematic jitter are statistically independent, they are uncorrelated; hence, their powers add. Therefore, to determine the systematic jitter power, subtract the random jitter power from the total ... -
TIA TIA-1116
Abstract: This document provides additional functionality to the functionality specified in [2] and later versions. It supports the allocation of a Home Agent in a visited network when a user is operating in a network that is not ...